fcc-e4-sec5

E4E|Noise and interference: external RF interference; electrical and computer noise; line noise; DSP filtering and noise reduction; common-mode current; surge protectors; single point ground panel

E4E01
EN
What problem can occur when using an automatic notch filter (ANF) to remove interfering carriers while receiving CW signals?
A. Removal of the CW signal as well as the interfering carrier ✓
B. Any nearby signal passing through the DSP system will overwhelm the desired signal
C. Excessive ringing
D. All these choices are correct

中文
用自动陷波器(ANF)在接收 CW 信号时消除干扰载频,可能出现什么问题?
A. 把 CW 信号连同干扰载频一起消除 ✓
B. 任何附近信号通过 DSP 系统都会淹没期望信号
C. 过度振铃
D. 以上选项都正确

【知识点解析】 自动陷波器可能把同频窄 CW 信号也当作干扰陷掉(尤其弱 CW)。
【考试提示】 – 实际应用:CW 下慎用 ANF。
– 易错点:陷波器可能误伤期望 CW。
E4E02
EN
Which of the following types of noise can often be reduced by a digital noise reduction?
A. Broadband white noise
B. Ignition noise
C. Power line noise
D. All these choices are correct ✓

中文
以下哪种噪声常可被数字降噪(DSP NR)减少?
A. 宽带白噪声
B. 点火噪声
C. 电力线噪声
D. 以上选项都正确 ✓

【知识点解析】 数字降噪(DSP NR)可减宽带白噪声、点火噪声、电力线噪声等多种背景噪声。
【考试提示】 – 实际应用:DSP 降噪通用有效。
– 易错点:不止一种噪声可降。

E4E03
EN
Which of the following types of noise are removed by a noise blanker?
A. Broadband white noise
B. Impulse noise ✓
C. Hum and buzz
D. All these choices are correct

中文
噪声消除器(noise blanker)可消除哪类噪声?
A. 宽带白噪声
B. 脉冲噪声 ✓
C. 哼声与交流声
D. 以上选项都正确

【知识点解析】 噪声消除器(blanker)针对脉冲噪声(如汽车点火、电刷火花)最有效。
【考试提示】 – 实际应用:消噪器对付脉冲干扰。
– 易错点:对连续白噪声效果差。
E4E04
EN
How can conducted noise from an automobile battery charging system be suppressed?
A. By installing filter capacitors in series with the alternator leads
B. By installing a noise suppression resistor and a blocking capacitor at the battery
C. By installing a high-pass filter in series with the radio’s power lead and a low-pass filter in parallel with the antenna feed line
D. By installing ferrite chokes on the charging system leads ✓

中文
如何抑制汽车蓄电池充电系统传导来的噪声?
A. 在发电机引线上串联滤波电容
B. 在蓄电池处安装噪声抑制电阻与隔直电容
C. 在电台电源引线串联高通、在天线馈线并联低通
D. 在充电系统引线上安装铁氧体磁环(扼流圈) ✓

【知识点解析】 汽车充电源(发电机)传导噪声用铁氧体扼流圈(磁环)套在引线上抑制。
【考试提示】 – 实际应用:车载电台电源引线加磁环。
– 易错点:铁氧体扼流是常用手段。
E4E05
EN
What is used to suppress radio frequency interference from a line-driven AC motor?
A. A high-pass filter in series with the motor’s power leads
B. A brute-force AC-line filter in series with the motor’s power leads ✓
C. A bypass capacitor in series with the motor’s field winding
D. A bypass choke in parallel with the motor’s field winding

中文
用什么抑制由交流电动机产生的射频干扰?
A. 在电机电源引线串联高通滤波器
B. 在电机电源引线串联强力(brute-force)交流线路滤波器 ✓
C. 在电机磁场绕组串联旁路电容
D. 在电机磁场绕组并联旁路扼流圈

【知识点解析】 交流电动机的射频干扰用串联在电源线的「强力」交流线路滤波器(X/Y 电容+共模电感)抑制。
【考试提示】 – 实际应用:电机/变频器加电源滤波器。
– 易错点:用串联线路滤波器,不是单电容。

E4E06
EN
What type of electrical interference can be caused by computer network equipment?
A. A loud AC hum in the audio output of your station’s receiver
B. A clicking noise at intervals of a few seconds
C. The appearance of unstable modulated or unmodulated signals at specific frequencies ✓
D. A whining-type noise that continually pulses off and on

中文
计算机网络设备可能造成哪种电气干扰?
A. 电台接收机音频输出中的响亮交流哼声
B. 每隔几秒的咔嗒声
C. 在特定频率出现不稳定已调或未调信号 ✓
D. 持续脉动式啸叫

【知识点解析】 网络设备(交换机/路由器/以太网)的时钟与谐波泄漏,在特定频率产生稳定或不稳定的信号。
【考试提示】 – 实际应用:网线/电源成辐射源,用铁氧体磁环。
– 易错点:表现为特定频率信号,非交流哼。
E4E07
EN
Which of the following can cause shielded cables to radiate or receive interference?
A. Low inductance ground connections at both ends of the shield
B. Common-mode currents on the shield and conductors ✓
C. Use of braided shielding material
D. Tying all ground connections to a common point resulting in differential-mode currents in the shield

中文
什么会导致屏蔽电缆辐射或接收干扰?
A. 屏蔽层两端低电感接地
B. 屏蔽层与导线上的共模电流 ✓
C. 使用编织屏蔽材料
D. 所有接地接到共点导致屏蔽层差模电流

【知识点解析】 屏蔽电缆因屏蔽层与内导体上存在共模电流而辐射/接收干扰(屏蔽失效主因)。
【考试提示】 – 实际应用:共模电流是屏蔽泄漏主机制。
– 易错点:问题在共模电流,不是低感接地本身。
E4E08
EN
What current flows equally on all conductors of an unshielded multiconductor cable?
A. Differential-mode current
B. Common-mode current ✓
C. Reactive current only
D. Magnetically-coupled current only

中文
非屏蔽多芯电缆上各导体相等的电流是什么电流?
A. 差模电流
B. 共模电流 ✓
C. 仅无功电流
D. 仅磁耦电流

【知识点解析】 非屏蔽多芯电缆上各导体相等的电流为共模电流(相对地/公共参考),是干扰辐射主机制。
【考试提示】 – 实际应用:共模电流是 EMI 主因。
– 易错点:共模=各导体同相相等,差模=来回成对。

E4E09
EN
What undesirable effect can occur when using a noise blanker?
A. Received audio in the speech range might have an echo effect
B. The audio frequency bandwidth of the received signal might be compressed
C. Strong signals may be distorted and appear to cause spurious emissions ✓
D. FM signals can no longer be demodulated

中文
使用噪声消除器可能产生什么不良效果?
A. 接收语音可能出现回声
B. 接收信号音频带宽被压缩
C. 强信号可能失真并看似产生杂散发射 ✓
D. FM 信号不能再解调

【知识点解析】 消噪器处理强信号/脉冲时可能使强信号失真,看似产生杂散发射。
【考试提示】 – 实际应用:消噪器误伤强信号。
– 易错点:不良效果是强信号失真,不是 FM 不能解。
E4E10
EN
Which of the following can create intermittent loud roaring or buzzing AC line interference?
A. Arcing contacts in a thermostatically controlled device
B. A defective doorbell or doorbell transformer inside a nearby residence
C. A malfunctioning illuminated advertising display
D. All these choices are correct ✓

中文
什么会造成间歇性响亮咆哮或嗡鸣的交流线路干扰?
A. 温控器中的电弧触点
B. 附近住宅内损坏的门铃或门铃变压器
C. 故障的霓虹广告灯
D. 以上选项都正确 ✓

【知识点解析】 上述设备的电弧/故障均产生间歇性交流线嗡鸣或咆哮干扰。
【考试提示】 – 实际应用:家中电气设备是常见干扰源。
– 易错点:多种设备均可导致。
E4E11
EN
What could be the cause of local AM broadcast band signals combining to generate spurious signals on the MF or HF bands?
A. One or more of the broadcast stations is transmitting an over-modulated signal
B. Nearby corroded metal connections are mixing and reradiating the broadcast signals ✓
C. You are receiving skywave signals from a distant station
D. Your station receiver IF amplifier stage is overloaded

中文
本地 AM 广播波段信号相互混合并在 MF 或 HF 段产生杂散信号,原因可能是什么?
A. 某广播台发射过调制信号
B. 附近腐蚀的金属连接处混频并重辐射广播信号 ✓
C. 你收到远端台的天空波
D. 你电台接收机中放级过载

【知识点解析】 附近腐蚀金属件(如栏杆、天线杆接头)充当非线性混合器,把本地 AM 广播混频后重辐射出杂散(「生锈螺栓」效应)。
【考试提示】 – 实际应用:锈蚀金属接头是隐形互调源。
– 易错点:根源是金属非线性混合,不是过调制。

E4E12
EN
What causes interference received as a series of carriers at regular intervals across a wide frequency range?
A. Switch-mode power supplies ✓
B. Radar transmitters
C. Wireless security camera transmitters
D. Electric fences

中文
什么会在宽频率范围上以固定间隔产生一系列载频干扰?
A. 开关电源 ✓
B. 雷达发射机
C. 无线安防摄像头发射机
D. 电围栏

【知识点解析】 开关电源(SMPS)以其开关频率的谐波产生周期性间隔的载频梳状干扰。
【考试提示】 – 实际应用:LED 电源/充电器/快充常见。
– 易错点:梳状等间隔→开关电源特征。
E4E13
EN
Where should a station AC surge protector be installed?
A. At the AC service panel
B. At an AC outlet
C. On the single point ground panel ✓
D. On a ground rod outside the station

中文
电台交流浪涌保护器应安装在何处?
A. 交流配电盘处
B. 交流插座处
C. 单点接地排上 ✓
D. 站外接地棒上

【知识点解析】 电台交流浪涌保护器应装在单点接地排(SPG)处,使保护地与系统地统一。
【考试提示】 – 实际应用:与单点接地配合(见 E4E14)。
– 易错点:装在 SPG,不是普通插座。
E4E14
EN
What is the purpose of a single point ground panel?
A. Remove AC power in case of a short-circuit
B. Prevent common-mode transients in multi-wire systems
C. Eliminate air gaps between protected and non-protected circuits
D. Ensure all lightning protectors activate at the same time ✓

中文
单点接地排(single point ground panel)的作用是什么?
A. 短路时切除交流电源
B. 防止多线系统中的共模瞬变
C. 消除保护与非保护电路之间的气隙
D. 确保所有避雷器同时动作 ✓

【知识点解析】 单点接地排让所有避雷器/保护器共地、同时动作,避免地电位差导致保护失效。
【考试提示】 – 实际应用:防雷接地统一到一点。
– 易错点:目的是统一地电位、同步动作。

We added this button so everyone can use our guides — including readers who find screens hard to use or who have visual impairments. Read more about why we built read-aloud.

Scroll to Top